Blemished – 80% Lower Fire/Safe Marked – Anodized Black

Overview

This is a blemished – 80% lower fire/safe marked – anodized black component for builders who prioritize function over finish. Each unit carries cosmetic imperfections from the machining or anodizing process, but retains full dimensional integrity and all critical features. The blemished – 80% lower fire/safe marked – anodized black designation means you receive a working lower receiver blank with visible surface marks, scratches, or anodizing inconsistencies. These parts are not seconds; they are first-quality blanks that failed visual inspection only. If you are building a rifle for hard use, a project gun, or a budget-conscious build, this blemished – 80% lower fire/safe marked – anodized black unit delivers the same mechanical specs as a premium part at a fraction of the retail cost.

Features & Specs

The blemished – 80% lower fire/safe marked – anodized black blank is machined from 7075-T6 aluminum and hardcoat anodized per Mil-Spec. The fire/safe markings are engraved and filled, and the pocket is cut to accept standard lower parts kits. All critical dimensions—trigger pocket, magazine well, and pin holes—are within spec. Cosmetic blemishes may include tool marks, small dings, uneven anodizing, or handling wear. No functional compromise exists on this blemished – 80% lower fire/safe marked – anodized black unit.

• Material: 7075-T6 aluminum, Type III hardcoat anodized black
• Markings: Engraved fire/safe selector markings, visible and legible
• Blemishes: Surface-level cosmetic defects only; no structural or dimensional issues

Who It’s For

This blemished – 80% lower fire/safe marked – anodized black blank is intended for individual builders, gunsmiths, and hobbyists who understand that a scratch on the exterior does not affect reliability. It suits anyone completing a personal firearm project, a beater rifle, or a test build where aesthetics are secondary. The blemished – 80% lower fire/safe marked – anodized black category also appeals to builders who intend to cerakote or refinish the part, since the cosmetic flaw will be covered. Whether you are a first-time builder or an experienced fabricator, this part offers a cost-effective way to move your project forward without paying for a perfect finish.

• Builders on a budget who want mil-spec dimensions
• Gunsmiths stocking project parts for customer builds
• Hobbyists who will refinish or bead-blast the part

Shipping & FFL

This blemished – 80% lower fire/safe marked – anodized black blank is an unfinished receiver and does not require transfer through a Federal Firearms License (FFL) dealer. It is not a firearm and may be shipped directly to your residence. You must be 18 years or older to purchase. Check your state and local laws regarding unfinished lower receivers before ordering. Some states and municipalities impose restrictions on 80% lowers. By purchasing, you confirm compliance with all applicable laws. No returns on blemished parts due to cosmetic condition.

• Shipped direct to your door — no FFL needed
• Must be 18+; buyer responsible for local legality
• No returns for cosmetic blemishes; inspect before installation